Oklahoma Drainage : 405-203-9419

Oklahoma Drainage –  We install French Drains, Channel Drains, Surface Drains, Sump Pumps and Sod.

If You live in Oklahoma City and water damaging your foundation, We can install a French Drain for you.

If you live in Norman and have water standing on your driveway, We can install a Channel Drain for you.

If you live in Edmond and have water flooding your basement, We can install a Sump Pump for you.

If you live in Moore and have water washing out your flower bed mulch, We can install a Surface Drain for you.

If you live in Yukon and need grass to grow we can install Sod too!

French Drain Installation In Downtown Oklahoma City

French Drain

A little bit North of Downtown Oklahoma City,  Oklahoma Drainage and Sprinkler Repair installed a 6 inch French Drain between two businesses which were less than three feet apart.  The French Drain went between a Law Firm and a Tire shop.  Water was leaking through the walls of both businesses.  Gutters between the two establishments were dumping a huge amount of water.  We installed a 6 inch French Drain between the two.

French Drain Running Through Low Areas

WHAT SIZE DRAIN PIPE FOR FRENCH DRAINS?

French Drains can utilize  several types and sizes of French Drain Pipe.  An older type that is not commonly used any more is 4 inch PVC Pipe with large half inch holes drilled in the Pipe.  This doesn’t work very well,   Because the holes are too large and the number of holes in the French Drain Pipe are too few.  Also there is no filter or “Soc” around this particular French Drain Pipe.  If it is used in sandy or loose soil the holes will clog and the pipe will fill up with sand.  PVC French Drain Pipe should be avoided.

ADS French Drain Pipe is much better, the holes are smaller and much more numerous.  It also comes inside a soc that acts as a filter and helps keep sand and debris out of the French Drain Pipe.  It works very well.

French Drain connected to gutter

It took a long time to get the dirt out of the trench for the French Drain.  It was a very tight fit.  We had to use a little red wagon to haul out the dirt for the French Drain and haul back in the crushed limestone for the French Drain.  It looked a little silly, but it was the only thing we could find that was narrow enough to fit between the buildings.  A French Drain that normally would take 1 day to install took three.

Curb Outlet for French Drain

The French Drain had a Double Exit Point.  This means that once water entered the French Drain Pipe, it could run South to the street or it could run North to the alley.  To exit points greatly increases the water capacity for any French Drain.

Along the course of the French Drain, we connected two large gutters directly into the Drain Pipe.

Once in place, the French Drain eliminated all the water that was leaking into the two buildings.

Drainage Problem Solved!