Oklahoma Drainage and Sprinkler Repair – 405 203 9419

French Drain Expert Oklahoma

Oklahoma Drainage and Sprinkler Repair – 405 203 9419

Do You have water in a place in your home or business that is a Problem?

Do you need help?

Oklahoma Drainage – 405 203 9419

We Install Drainage Systems to fit various needs for home owners an businesses.  A Drainage System, can utilize French Drains, Surface Drains, Channel Drains or Sump Pumps as the intake part to the Drainage System.  The Drain or Sump Pump brings water into the Drainpipe.  The Drainpipe takes the water to the ” Exit.”  Which is Either a “Curb Outlet” or a “ Pop Up Emitter.”

The Three parts of A Drainage System are:

THE  INTAKE ( French Drain or Surface Drain ) etc.  The TRANSITION ( The Pipe) which can be many sizes or type. The EXIT ( A Curb Outlet or Pop Up Emitter )

Curb outlet with more than 6 inches of fall

Curb Outlet as an Exit Point for a French Drain in Edmond

The Drainage

part of our company name means that we solve water problems for people in Oklahoma.  Heavy rain is becoming more common.  Back in 1993 when I first started, a hard rain was considered to be about an Inch per/hour.  It was fairly rare but not too uncommon.  Today things are different.  A weather report of rain fall at or above 4 inches per/hour was not uncommon in 2019.  Excess water causes all types of damage to property both residential and commercial.

Our Drainage Systems drain water away from places you don’t want it to be.  You might have water standing along the foundation of your house, or inside your basement.  You might have water on your driveway or flowerbed too.

Designing a French Drain or a Drainage System

When I talk to a potential customer while doing a Drainage System estimate, I take a lot of things into consideration.  First I have the Customer show me where water is standing or where it is going that it shouldn’t.  This is part of defining the specific problem area.  Sometimes the Water Problem Area is larger and more involved than the customer realizes.  Once the Water Problem Area is clearly defined,  the next step is to determine how the water is getting to the problem area.  Many times there is more than one Water Source to the Water Problem area.

A big mistake

in Drainage System Design is to stop once the most obvious Water Source is found.  A Drainage System Designer must be a detective to some degree.  For Example:  Water running down the hill and onto the back patio might be the most obvious water source.  Sub-surface water or a neighbor’s new gutter downspout could also be contributing.  Most of the time water gets into the problem area from more than one source.

Next you must decide where to take the water.  This is determining an Exit Point for the Drainage System.  If possible, you want your exit point to be down hill from the problem area.  If it is up hill in all directions from the problem area, then the only solution is a Sump Pump.

Once an exit Point is determined, you must ask yourself if there is any way to install two exit points.  Usually this can only work when an exit point can work on both ends of a Drainage System.  The benefit of two Exit Points in a Drainage System is it greatly increases the water capacity for the Drainage System.  It can move much more water faster during a heavy rain than a system with just one Exit Point.  Most Drainage Systems can only utilize one Exit Point.  In 21 years of Drainage System Installation,  I would say 10% of our Drainage Systems have two Exit Points.