Midwest City Sprinkler Repair
Oklahoma Drainage and Sprinkler Repair – Expert Sprinkler Repair for all Residential Lawn Sprinkler Systems
We service all of Central and Western Oklahoma
Since 1993 we have:
Fixed leaking sprinkler pipes in Edmond
Replaced Sprinkler Valves in Norman
Adjusted Sprinkler Heads in Oklahoma City
Installed A New Back Flow Valve in Lawton
over 2000 other Sprinkler Repairs in Central and Western Oklahoma.
Sprinkler Repair Oklahoma City. Oklahoma Drainage and Sprinkler Repair provides Expert Service for Sprinkler Heads, Valves, Controllers and all other Sprinkler System difficulties. We service Norman, Edmond, Oklahoma City, Moore, Yukon, Mustang, Blanchard, and Midwest City
Sometimes things go wrong with sprinkler systems.
Sprinkler Head Adjustment
OKLAHOMA DRAINAGE AND SPRINKLER REPAIR. 405 203 9419
One Common problem is that they continue to run and won’t shut off. In most cases this is a problem with a sprinkler valve that has “Stuck” in the on position.
This can be temporarily solved by shutting of the Emergency Shutoff Valve.
The problem is
that some sprinkler systems don’t have one to turn off or if they do the homeowner doesn’t know where it is.
It may be on the back-flow valve which may be located on the side of the house under a big plastic fake rock.
Many sprinkler systems in Oklahoma have them. (50 % ?) Under the plastic rock is a back-flow valve with two shut off handles. Usually, they have blue or green or tan handles. Turn one of the handles and it should shut off the water to your sprinkler system.
Other times the Emergency Shutoff Valve is in a box in the ground out by the curb near your water meter. The valve box will have a green lid. Sometimes they are difficult to open. Many times, I had to pry them open with a flat head screwdriver.
Inside the valve box is a plastic handle that can turn off the water to the sprinkler system. It can be blue or red or grey in color.
Many times, the valve box will be full of dirt, and you can’t turn or even see the handle until some of the dirt has been dug out by hand.
Water might be shooting up in the air somewhere on your property. This can be caused by a broken sprinkler pipe or sprinkler valve.
SHUT OFF THE SPRINKLER WATER IF YOU CAN AND GIVE US A CALL.
OKLAHOMA DRAINAGE AND SPRINKLER REPAIR. SERVICING ALL OF CENTRAL AND WESTERN OKLAHOMA.
405 203 9419
Servicing Oklahoma City, Norman, Edmond and all of Central and Western Oklahoma
Sprinkler Controller Repair is a service provided by Oklahoma Drainage. A Sprinkler Controller is the “Brain,” of a Sprinkler System. They can wear out or stop working. Power surges in the home can cause damage to a controller.
Programming can be difficult for homeowners. We can help with programming or replace a Sprinkler Module if it is defective.
Start Time Programming
“Start Time” programing many times is confusing for homeowners. The definition of a Start Time is a time that is chosen for the sprinkler system to start watering. It causes zone 1 to start running. When zone 1 is finished it automatically stops and zone 2 begins. When Zone 2 is complete it stops and zone 3 begins. Simple enough Right! This continues until the last zone programed available runs.
The confusion begins when people think that a time needs to be set to start zone 2 and 3 and so on. This is not the case. They follow zone 1 which has the only Start Time programmed into the controller.
Be Careful with Multiple Start Times, just use One at first.
Sprinkler Controllers have a feature providing multiple start times, up to 4 Start Times are usually available. These additional start times are only used when a person wants to run the entire system more than once in a 24-hour period.
For Example, the first Start Time is set at 9Am. Zone 1 begins to run at 9am. When Zone 1 is done, say 10 minutes later, Zone 2 begins and runs for 10 minutes, then zone 3 follows and so on. By 10 am let’s say all the zones have run. Let’s say 8 hours later you have a second start time at 6 Pm. Zone 1 comes on and runs and by 7pm all the zones have run again. So, the controller has 2 start times which have caused the Sprinkler System to run start to finish twice in a 24-hour period.
Here is the big problem!
Some Homeowners believe the second start time is to start zone 2 running. They also think that the 3rd start time is to start zone 3 and the 4-start time is to run zone 4. No!!
So, this is how they program the controller. At 9am they have a start time and zone 1 starts. The homeowner programs a second start time at 9:10 am to mistakenly start zone 2. Nope! It starts zone 1 all over again. At 9:2o they have a 3rd start time for zone 3. Nope! It starts zone 1 for a third time. Now the controller is stuck in a loop and zone 1 runs constantly and won’t shut off.
If Sprinkler Controller Programming is confusing? Make sure you only have One Start Time!
“Run Time,” is completed Next. It determines how long each zone runs. Zone One 10 Minutes, Zone Two, 15 Minutes, Zone Three 8 Minutes. You can set how long you want each zone to run.
French Drain Repair and Installation is a Central Focus for Oklahoma Drainage. We installed our first French Drain and completed our first Sprinkler Repair in Norman in 1993.
Oklahoma Drainage and Sprinkler Repair — Installing – French Drains – Surface Drains – Channel Drains – Sump Pumps.
Providing Expert Sprinkler Repair – Broken Sprinkler Pipes – Sprinkler Head Adjustment – Sprinkler Valve Replacement
We provide Service for Folks in: Norman, Oklahoma City, Edmond, and Moore.
Central and Western Oklahoma is our Service Area since 1993.
(405) 203-9419
Sprinkler Repair Oklahoma City
What Is a Sprinkler Valve?
Think of a Sprinkler Valve as an “Off or On” Switch. The Sprinkler Controller turns the valves on or off.
It Sends a signal through a wire which is underground to the sprinkler valve somewhere in your yard.
Once turned on, the valve lets water pass through a sprinkler pipe to a specific group of sprinkler heads called a Sprinkler Zone. The controller allows water to reach the sprinkler heads for a certain amount of time running through the sprinkler valve. Once the time is up, it shuts off the sprinkler valve and moves on to the next valve in sequence.
Think of it as walking into every room in your house one at a time. As you enter you turn on the light. As you leave you turn off the light and move to the next room. You are the controller. The light switch represents the sprinkler valve.
What causes a Sprinkler Valve to stop working?
Like anything else, a sprinkler valve can wear out. Sprinkler valves fail in closed position. It won’t run continuously if it breaks.
Sprinkler Valves get stuck while running sometimes. The water supply must be then turned off to stop the Sprinkler from running.
Sprinkler Valves can freeze and break in the winter if the sprinkler system has not been properly drained for winter’s cold.
(winterized)
Tree roots
can twist or break sprinkler pipes running into sprinkler valves. Magnolia Trees are really bad about this. Oak trees can cause damage too.
Driving something heavy across your yard can crush sprinkler valves. Usually riding lawnmowers don’t cause damage but any truck or car will if you drive over a valve.
Sprinkler Repair Service Provided by Oklahoma Drainage and Sprinkler Repair
Since 1993 we have Replaced Sprinkler Valves that were sticking or were wore out.
Thousands of Sprinkler Heads have been adjusted.
Countless Sprinkler Controllers have been Reprogramed or Replaced.
We also have fixed a broken Sprinkler Pipe or Two. Seems like a million. Ok, not that many.
I wonder how many? A lot!!!!
Oklahoma Drainage and Sprinkler Repair provides Service for all of Central Oklahoma Including: Oklahoma City, Norman, Edmond, Moore, Yukon and Mustang.
Oklahoma Drainage and Sprinkler Repair — Installing – French Drains – Surface Drains – Channel Drains – Sump Pumps.
Providing Expert Sprinkler Repair – Broken Sprinkler Pipes – Sprinkler Head Adjustment – Sprinkler Valve Replacement
We provide Service for Folks in: Norman, Oklahoma City, Edmond, and Moore.
Central and Western Oklahoma is our Service Area since 1993.
(405) 203-9419
Oklahoma Drainage and Sprinkler Repair
– Since 1993 we have provided Expert Sprinkler Repair for Norman, Edmond, and Oklahoma City.
Recently we spent an afternoon checking out a Sprinkler System in Northwest Oklahoma City. The customer told us that many of the heads in the Sprinkler System had a variety of problems. Her Sprinkler System was fairly large so the Sprinkler System Checkup would take some time.
First, we had to run each Sprinkler Zone and look at each Sprinkler Head individually. This took a while considering that there were 18 zones and 5 to 10 Sprinkler Heads in Each Zone.
Sprinkler Head Adjustment
First, we looked to see if each Sprinkler Head was functioning correctly. Many of the heads were leaking at the base. Other Sprinkler Heads were not spraying correctly and needed to have their Sprinkler Nozzles Replaced. Some of the Sprinklers were just worn out and needed to be replaced.
As we went through the Sprinkler System, we placed a flag by each head that needed some type or Sprinkler Repair or Replacement. Along the way we also checked Sprinkler Coverage. Some Sprinkler Heads needed to be moved because some areas were either too dry or too wet. Several Sprinkler Heads needed to be moved.
Before the end of the day, we replaced 12 Sprinkler Heads, Changed Out 35 Sprinkler Nozzles, and moved 11 sprinkler heads to new locations.
