Oklahoma Drainage and Sprinkler Repair – 405 203 9419

Oklahoma Drainage  405 203 9419 — We provide:

    French Drain Installation, Surface Drain Installation, Drainage System Installation

French Drain Running Through Low Areas

WHAT SIZE DRAINPIPE FOR FRENCH DRAINS?

French Drains can be decorated with many types of stone

French Drains can utilize  several types and sizes of French Drainpipe.  An older type that is not commonly used any more is 4 inch PVC Pipe with large half inch holes drilled in the Pipe.  This doesn’t work very well,  Because the holes are too large and the number of holes in the French Drainpipe are too few.  Also there is no filter or “Soc” around this particular French Drainpipe.  If it is used in sandy or loose soil the holes will clog and the pipe will fill up with sand.  PVC French Drainpipe should be avoided.

ADS French Drainpipe

ADS French Drainpipe is much better, the holes are smaller and much more numerous.  It also comes inside a soc that acts as a filter and helps keep sand and debris out of the French Drainpipe.  It works very well.

French Drain in flowerbed

For Small business and Residential French Drains, Four inch ADS Perf/Soc French Drainpipe is adequate and the most common.  It is used for the majority of all French Drains installed.  French Drains can be installed using 3 inch ADS Perf/Soc but many times it is too small and can be overwhelmed by a heavy rain or from a bad design.  (Too many gutter down spouts connected directly into the French Drain, For Example) Three Inch French Drainpipe should be avoided if possible.

6 Inch ADS French Drain

Six inch  ADS Perf/Soc French Drainpipe is usually a good idea when possible.  It carries a much larger volume of water.  Six Inch French Drains are rarely overwhelmed.

Installing Gravel on top of a 6 inch French Drain

The Drawbacks to 6 inch French Drain installation are:

Yukon French Drain

French Drain Installation In Yukon Oklahoma Drainage : Servicing all of Central and Western Oklahoma since 1993.Standing Water on Your Driveway?  A Surface Drain set in concrete may be what you need. Or maybe you need a French Drain Running alongside your driveway instead.  Handling water problems is what we are good at.  If you need help, Oklahoma Drainage can provide the best solution for your unwanted water problems.

A good place for a French Drain

Drainage System in Yukon

Drainage System in Yukon We just finished a 4 inch Drainage System in Yukon.  It was a complicated system to install.  It utilized 4 inch French Drain in the flower beds, 12 inch Surface Drains on the side of the house, 6 inch French Drain along the garage foundation with 2 Pop – Up Emitters in the back yard and 3 Curb Fittings in the front.

First we installed 4 inch French Drain in the flowerbeds on both sides of the front door.  We connected 4 inch solid Drain Pipe into the French Drain and ran them underside walk to the curb.  Next we cut the curb with a concrete saw and installed 3 curb outlets for 3 separate French Drains.

French Drain Installed in Yukon

12 Inch Drain Basin

Next we installed 4 12 Inch Drain Basins with grates along both sides of the house continuing with Solid Drainpipe to the Pop-Up Emitters on the back fence.

Finally, we completed the Drainage System by installing a long run of 6-inch French Drain down the side of the garage foundation.   Installing the French Drains in the flower beds was the most difficult and took the most time.  Each French Drain took over a ton of crushed limestone to fill the French Drain trench.  The Six inch French Drain took even more limestone.

 Oklahoma Drainage and Sprinkler Repair –

Hey Oklahoma, We are expanding to service all of Western Oklahoma as well as Central Oklahoma.  If you live in Elk City, and need a French Drain, we can help.  If water is standing on your driveway in Clinton, Give us a call.  Duncan, Lawton, and Altus are all new areas of service for us.

Since 1993 Oklahoma Drainage and Sprinkler Repair has solved all types of standing water and drainage issues.  We install Drainage Systems that utilize French Drains, Surface Drains, Channel Drains, and Sump Pumps depending on the customer’s needs.

If you have water in the wrong place, we can help! We also have Decades of experience repairing all types of Lawn Sprinkler Problems.  Fixing broken sprinkler heads, sprinkler valve problems and controller trouble just to name a few things.

French Drains as part of a Drainage System – 

Many times people use the term ” French Drain” as general name for a Drain used in or around your home.  French Drains are designed to move a lot of water over a large, flooded area.  They are also designed to take water in on the surface of the ground or below the surface of the ground.  This is very important if the water coming into the flooded area is moving through the ground or coming up from underneath.  ” Sub Surface Water Movement.”  The picture below is not a French Drain!

Surface Drain

A French Drain Can Handle Standing Water

A French Drain can take in water in a broad area.  It can move a much larger volume of water compared to a Surface Drain.  Also, it can move sub surface water moving into the area where a Surface Drain won’t move any water at all.

Surface Drains

are designed to move surface water only on a smaller scale in confined areas.

Each solves specific drainage problems.  A Drainage System may use one or both together or even several using many types of drains.

Standing Water

Do you have standing water in a large area in your yard?  Typically, this calls for a French Drain.  A French Drain is a great way to control standing water in a large grassy area.  It can also protect areas from flooding to a certain degree.  As long as the French Drains capacity to move water is not exceeded.

If the French Drains capacity is exceeded, then water will stand in the drainage area until the rain stops and the drain has time to catch up.  A good way to prevent this is to install a bigger French Drain with a larger pipe.  The difference between a 3 inch French Drain and a 6 inch French Drain is huge.

Another way to beef up a French Drain is to connect gutter down spouts in front of the French Drain.  The water coming off the roof causes suction in the French Drain Behind it.  This greatly increases the French Drains ability to move water without increasing the size of the French Drainpipe.

Gutter Downspout Connected to 6 Inch French Drain

French Drain Inside a Courtyard

Recently we installed a French Drain inside the courtyard of a rest home in Norman.  We had several interesting challenges to overcome that were not typical for a French Drain Installation.

The courtyard was in the center of the home and was a secure area for the patrons.  We had to put down painters tarps to run our wheelbarrows over.

Lots of Dirt to Remove

We took out 44 loads of dirt and brought in 52 loads of Crushed one inch limestone for the French Drain.  Each trip was over a hundred yards from the trailer in the parking lot, in the front door, down the hall, making two turns along the way.

Each time we had to be escorted by security.  Needless to say, the installation of this particular drainage system took a while. In the above picture, the French Drain runs along the low area crossing all the areas where water would stand each time it rained.

French Drain in Rest Home Courtyard

Big Mistake

When a French Drain is installed, a big mistake that is made by many people is to cover up the gravel with dirt.  This is a big mistake.  Basically it is ” Putting the cork back in the bottle.”  If the French Drain is in full sun and has a type of grass surrounding it that spreads on its own such a ” Tift” or “Bermuda” , Grass will grow over it and the French Drain will eventually disappear.  Grass covering a French Drain is a good thing if it grows across the drain without adding dirt.  The Grass thatch acts a water filter preventing clogging and extending the life of the Drainage System.

Full Shade

When a French Drain is in Full Shade, or the surrounding grass will not spread on its own, such as with Fescue,  other steps must be taken.  One option is to just leave it alone.  If you don’t mind how it looks, it will drain a large amount of water for many years.  Many times a French Drain can be a landscaping focal point.  They can be dressed up with all kinds of Rocks and Stones and Plants.

Just what is a “French Drain?”  Many times people incorrectly

use the phrase, “French Drain,”  to apply to many different types of Drains that could be used in a Drainage System.  The term is widely used and many times incorrectly connected to “Surface Drains,” or “Channel Drains.”

Surface Drain

A Surface Drain has a grate that sits on top of a basin.  The basin is underground.  A Drainpipe is connected underground to an outlet on the Drain Basin.  Stormwater Drains through the grate into the Drain Basin.  Once in the Drain Basin, water travels out of the basin through a Drainpipe.  The Stormwater continues downhill in an underground Drainpipe to an exit point.

THIS IS NOT A FRENCH DRAIN!

A Surface Drain may come in many different shapes or sizes.  The Drain Grate may be round or square.  Here is a picture of a common Surface Drain.

A Channel Drain is a type of Surface Drain and many times is installed in concrete across sidewalks or driveways.

A French Drain is completely different from a Surface Drain.  A basic French Drain consists of a Perforated Drainpipe in the bottom of a trench.  The Drainpipe should have a neoprene sock around the Perforated Drainpipe.   This is to ensure that the Drainpipe does not become clogged.

The dirt that was taken out to make the trench is hauled away.  It is replaced by some type of small stone or gravel depending on what is desired or available.

Crushed Limestone

I prefer crushed 1 inch limestone.  It is the most economical option in my area.  Pea Gravel or some other type of small stone can work just as well.    The limestone or gravel is placed in the trench on top of the perforated Drainpipe and filled all the way to the surface (ground level).

In some cases where the French Drain needs to be deep or is being placed in sandy soil, a special trench liner must be placed in the trench before the perforated Drainpipe, or the Gravel are installed.  This helps maintain the integrity of the trench over time.  It also increases the cost of the French Drain and the amount of time to install it.  I install a trench liner in a French Drain every time.

French Drain Downfall

Installing Cement around Curb Fitting for French Drain

French Drain Benefits

A French Drain will move large amounts of water from the Drainage Problem Area to the Exit point.

A French Drain Will Drain away water that gets to the Drainage Problem Area in 3 ways.

1.  Water gets to the problem area by falling from the sky.

2.  Water gets to the problem area by flowing downhill over the ground.

3.  Water gets to the problem area by flowing underground. (Sub-Surface water flow)

Underground Water Flow

Number 3, Sub-Surface water flow is the big consideration.  When doing a Drainage Diagnostic, this is the area that is many times missed or not considered by less experienced companies.  Oklahoma Drainage and Sprinkler Repair rely on 33 years of experience.

Many Times, it is cheaper and more effective to install a French Drain over a Surface Drain.  A Surface Drain can’t move as much water as a French Drain, and a Surface Drain can’t Drain away Sub-Surface water.  Surface Drains should be installed in areas where the Drainage Problem area is smaller and is not affected by sub-surface water.

The drawback to a French Drain, is that it is not a pretty as a Surface Drain.

French Drains do a great job running along foundations and driveways.  A French Drain will keep water away from cement and prevent damage to concrete if water should freeze up against it.  A French Drain can keep your foundation Dry.