French Drain Setup, Design and Information in Oklahoma City, Edmond, Norman,

Posted: February 5, 2015 in french drain, French Drain Design, French Drain Information
Tags: , ,

French Drain Setup

 

French Drain InstallationFrench Drains are designed to do a lot of things. If you have an area that has unwanted water standing in it or running across it, a French Drain can be the answer.

A French Drain is a trench that runs across the Drainage Problem Area.

A French Drainpipe is placed in the bottom of the trench. The French Drainpipe is perforated with thousands of small holes. In most cases the Drainpipe has a nylon soc around the pipe to act as a filter for the French Drain. The French Drain trench is then filled with some type of small rock or stone.

 

Oklahoma Drainage and Sprinkler Repair — Installing – French DrainsSurface DrainsChannel DrainsSump Pumps.

Providing Expert Sprinkler Repair – Broken Sprinkler Pipes Sprinkler Head AdjustmentSprinkler Valve Replacement

We provide Service for Folks in: Norman, Oklahoma City, Edmond, and Moore.

Central and Western Oklahoma is our Service Area since 1993.  

                                                           (405) 203-9419

 

 

Oklahoma Drainage

typically uses crushed 1 inch Limestone to cover the French Drainpipe. The dirt that was dug out of the trench is taken away or spread out around the French Drain. The Limestone replaces the dirt and fills the French Drain Trench all the way to the surface.

Large 6 Inch French Drain Installed in Norman

Large 6 Inch French Drain Installed in Norman

When water come in contact with the French Drain, it seeps down through the stones and into the French Drainpipe. It then flows through the Drainpipe to the exit point. Typically, a French Drain will have two possible exit points. The First is called a “Pop-Up Emitter.” It is a Green Lid on top of a release basin for the French Drain.

Popup Emitter to release water from a Drainage System in Yukon.

Popup Emitter to release water from a Drainage System in Yukon.

The second type of Exit Point for a French Drain is a “Curb Fitting.” The Curb Fitting is installed through the curb going out into the street. The French Drainpipe runs to the Curb. The curb is cut out, and the Curb Fitting is cemented through the Curb.

Installing a Curb Outlet for a French Drain in Edmond

Installing a Curb Fitting for a French Drain in Edmond

French Drains are designed to move large amounts of water. A French Drain moves water away from the Drainage Problem area from the Surface like a large Surface Drain, But also below ground, or sub surface. Most people don’t take into account the water that flows to a problem area underground. Sub surface water flow is not eliminated by a Surface Drain. A French Drain can move away water that is below the surface of the ground and drain away water that is on the surface.

Yukon Installation

We just finished a 4 inch Drainage System in Yukon

on. It was a complicated system to install. It utilized 4 inch French Drain in the flower beds, 12 inch Surface Drains on the side of the house, 6 inch French Drain along the garage foundation with 2 Pop – Up Emitters in the back yard and 3 Curb Fittings in the front. First we installed 4 inch French Drain in the flowerbeds on both sides of the front door. We connected 4 inch solid Drainpipe into the French Drain and ran them underside walk to the curb. Next we cut the curb with a concrete saw and installed 3 curb outlets for 3 separate French Drains.

Installing a Curb Outlet for a French Drain in Oklahoma City

Installing a Curb Outlet for a French Drain in Oklahoma City

Next

we installed 4 12 Inch Drain Basins with grates along both sides of the house continuing with Drainpipe  running to the Pop-Up Emitters on the back fence. Finally we completed the Drainage System by installing a long run of 6 inch French Drain down the side of the garage foundation. Installing the French Drains in the flower beds was the most difficult and took the most time. Each French Drain took over a ton of crushed limestone to fill the French Drain trench. The Six-inch French Drain took even more limestone.

French Drain in Oklahoma City

Drainage System Installation in Norman
Drainage System Installation in Norman
Comments
  1. […] that also installs drains.”  They all can install Drainage Systems, Just not very well.  CMG has over 20 years of experience Diagnosing Drainage Problems.  This ensures that a Drainage […]

  2. […] kinds of problems.  Concrete in driveways, sidewalks, and foundations can be damaged.  Prolonged Drainage Problems allow mold to occur along with deterioration to plants, trees, and […]

  3. […] French Drain Design and Information in Oklahoma City February 5, 2015French Drain Installation —   French Drains are designed to do a lot of things.  If you have an area that has unwanted water standing in it or running across it, a French Drain can be the answer.  A French Drain is a trench that runs across the Drainage Problem Area.  A French Drain Pipe is […] blanecallen […]

Leave a Reply