Norman Oklahoma French Drain Installation Is the Central Focus for Oklahoma Drainage.
We installed a “Double 4-inch Horseshoe French Drain,” on Harrogate Avenue in Brookhaven which is in West Norman.
A Double 4-inch Horseshoe French Drain sounds complicated, but it is relatively simple.
A Double 4-inch Horseshoe French Drain? Is that even a real thing? Ah, yes!
This type of French Drain has Two 4-inch French Drainpipes in the bottom of the Drainage Trench instead of One. In this application, they are placed side-by-side in the bottom of the trench instead of stacking them on top of each other.
Side-by-side placement was necessary for 2 reasons. Fist we needed two pipes to carry a huge amount of water that would overwhelm a single pipe.
The second reason was the lack of slope available. The back yard was where the flooding occurred. There was very little slope from the back yard to the front. The French Drain needed to be installed in the back yard with the water draining out through the curb in the front yard.
Normally we would use one 6-inch Drainpipe.
Normally we would have used one Six-Inch French Drainpipe instead of 2 Four Inch Pipes. Because there was very little slope from the back yard to the front yard. The 6-inch Drainpipe would be too tall and stuck out of the ground. The shorter 4-inch pipe worked well.
Because of flooding in the customer’s back yard, we needed to move as much water as possible. Having 2 exits instead of one in a Drainage System greatly increases the amount of water that can be moved.
Picture this!
The Double 4-inch French Drain went all the way around the customers back yard. On the East side of the house, we ran Drainpipes down the side of the house heading toward the front yard. The Drainpipes were taken across the front yard, to the curb.
On the West side of the house, we did exactly the same thing taking Drainpipes down the West side across the front yard to the curb.
This meant that we had two drainpipes exiting out through the curb on the West side of the driveway and two Pipes exiting the curb on the East side of the driveway.
Horseshoe French Drain
A Drainage System with 2 Exits that runs from the street all the way around the house and back to the street is called a, ” Horseshoe French Drain.” The Drainage System is shaped like a,” Horseshoe.” This is a name that Oklahoma Drainage has, “Coined.” We came up with this term over 30 years ago.
We were almost finished with the Drainage System installation described above, when the rain hit. It rained very hard for a long time.
Everything was finished except the curb outlets on both sides of the driveway. The Drainpipe ran to the Curb, but the Curb Outlets had not been installed yet. We had to wait till the rain stopped to cut the curbs and install the cement curb outlets.
Oh, my goodness! The Double 4-inch Horseshoe French Drain really moved the water!
Norman Oklahoma French Drain Installation
We came back a few days later and installed the Curb Outlets.
Since we installed the Drainage System previously mentioned, our customer no longer has flooding problems in his backyard.
Oklahoma Drainage— 405 203 9419- Servicing all of Central and Western Oklahoma
Norman is where it all began for us! In 1993 Oklahoma Drainage Installed its first French Drain in Brookhaven in Western Norman. Since then, we have installed Drainage Systems in more than thirty Oklahoma towns and cities. Check out List of Cities.
FRENCH DRAIN, SURFACE DRAIN, PICTURES AND INFORMATION Standing water can cause many types of property damage ranging from foundation problems to cracked sidewalks and dead plants and shrubs. If you have need of French Drain or Surface Drain, give us a call. We provide free estimates for all of central Oklahoma.
Norman Oklahoma French Drain Installation
Oklahoma Drainage 405 203 9419 — We provide:
French Drain Installation, Surface Drain Installation, Drainage System Installation
Norman Oklahoma French Drain Installation
Installing Trench Liner for French Drain
French Drain Installation in Norman Oklahoma
Oklahoma Drainage Installs Surface Drains and French Drains. Sometimes it is up hill in all directions from the Problem Drainage Area. This problem can be solved by installing a Sump Pump. When the cavity fills, the water is pumped away to the point where the water exits the drain which can be a curb outlet or a pop-up emitter.
Check out the photo below. It is a dual Sump Pump System Installed in Oklahoma City. You should consider a Sump Pump Drainage System if it is uphill in all directions from your Problem Drainage Area.
You should consider a Surface Drain
If you have water standing on concrete. Check out the picture above. We installed 12″ Drain Basins with Metal Grates set in concrete. Below, Oklahoma Drainage installed a Channel Drain all the way across a driveway. The 12″inch Drain Basins are a better solution if there is a lot of Debris in the water on the driveway. The Channel Drain below is a better solution if the Surface Water on the driveway is comparatively less muddy.
Surface Drain set in concrete
Sprinkler System Checkup Norman.
Lots of things can be done to make sure your Sprinkler System is ready to go. All the Sprinkler Zones should be checked one by one. The sprinkler heads and valves need to be checked to see if anything needs to be adjusted or replaced.
Sprinkler System Checkup is a Service Provided by Oklahoma Drainage since 1993.
Today we did a sprinkler repair in Norman. The sprinkler system needed a checkup.
We went through each sprinkler zone and identified several different problems.
Zone 2 had a cracked sprinkler pipe in a flower bed.
A broken Rotor Sprinkler head was found immediately.
Next, zone five look good with no problems.
Zone 6 and 7 each had a couple of pop-up spray heads that were worn out and would not pop-up. The diagnosis and the repair took less than two hours. Now their sprinkler system is running great!
Now is a good time to have a Sprinkler System Checkup provided by Oklahoma Drainage.
Sprinkler Systems need to be checked before winter to prevent pipes from freezing. Sprinkler Design determines whether sprinkler lines need to be bled. Emergency shut off valves also need to be checked and turned off for the winter.
In the Spring, all the water needs to be turned back on and all sprinkler zones and heads need to be tested.
Sprinkler Repair Service Provided by Oklahoma Drainage and Sprinkler Repair
Since 1993 we have Replaced Sprinkler Valves that were sticking or were wore out.
Thousands of Sprinkler Heads have been adjusted.
Countless Sprinkler Controllers have been Reprogramed or Replaced.
We also have fixed a broken Sprinkler Pipe or Two. Seems like a million. Ok, not that many.
I wonder how many? A lot!!!!
Oklahoma Drainage and Sprinkler Repair provide Service for all of Central Oklahoma Including: Oklahoma City, Norman, Edmond, Moore, Yukon and Mustang.
Sprinkler Valves
Sprinkler Valve Replacement is a service that Oklahoma Drainage has provided Since 1993. Recently we removed 3 Rainbird Sprinkler Valves and replaced them with new ones. The valves had been crushed accidentally when a landscaper drove his truck across the yard.
Sprinkler System Check-Up in Edmond, Oklahoma City, Norman, and Moore.
Sprinkler System Check-Up process is very straightforward. We run through all the Sprinkler Zones one-at-a- time from the controller.
Sprinkler Controller
Sprinkler controllers can be a problem source. Many times, the wires in the controller are loose or have a “Short” in one of the wires. Sprinkler Programming can be a source of frustration. We can help with Programming your controller.
We check all the sprinkler heads in that zone and the valves as well.
Once the Sprinkler System Checkup is Complete, we provide a Quote for what it will cost to make the needed repairs.
Oklahoma Drainage and Sprinkler Repair — Installing – French Drains – Surface Drains – Channel Drains – Sump Pumps.
Providing Expert Sprinkler Repair – Broken Sprinkler Pipes – Sprinkler Head Adjustment – Sprinkler Valve Replacement
Servicing all of Central and Western Oklahoma since 1993. 405 203 9419
Sprinkler Valve Replacement is a service that Oklahoma Drainage has provided Since 1993. Recently we removed 3 Rainbird Sprinkler Valves and replaced them with new ones. The valves had been crushed accidentally when a landscaper drove his truck across the yard.
Sprinkler Repair Service Provided by Oklahoma Drainage and Sprinkler Repair
Since 1993 we have Replaced Sprinkler Valves that were sticking or were wore out.
Thousands of Sprinkler Heads have been adjusted.
Countless Sprinkler Controllers have been Reprogramed or Replaced.
We also have fixed a broken Sprinkler Pipe or Two. Seems like a million. Ok, not that many.
I wonder how many? A lot!!!!
Oklahoma Drainage and Sprinkler Repair provide Service for all of Central Oklahoma Including: Oklahoma City, Norman, Edmond, Moore, Yukon and Mustang.
First Step
First, we dug up a good working area surrounding the broken Sprinkler Valves. Next, we cut out the broken valves and crushed PVC pipes. Finally, PVC pipe was cut and glued with new Sprinkler Valves following the original design and configuration. In this case the three original sprinkler valves were connected to each other inside one Valve Box.
We aren’t done yet though; two sprinkler wires must be connected to each Valve. One sprinkler wire is the “Common Ground.” The other wire is the power wire. All the sprinkler wiring is connected with water-proof wire connections.
The Common Ground wire and the Individual Power Wires all come from the Sprinkler Controller. Each Sprinkler Valve has its own power wire coming from the Controller. All the Sprinkler Valves are Connected to the Same Common Ground Wire.
Oklahoma City Sprinkler Repair
Before We Finish
Before dirt can be put back around the new valves, testing must be done. Each valve must be turned on, “one-at-a-time,” at the Controller to ensure good wire connection and functionality. Also, the Sprinkler Valves must be checked for leaks in the PVC Pipe.
Oklahoma Drainage and Sprinkler Repair provides Expert Service for Sprinkler Heads, Valves, Controllers and all other Sprinkler System difficulties. We service Norman, Edmond, Oklahoma City, Moore, Yukon, Mustang, and Midwest City.
Blanchard Sprinkler Repair has been provided by Oklahoma Drainage and Sprinkler Repair since 1993.
Sprinkler Controller Repair is a service provided by Oklahoma Drainage. A Sprinkler Controller is the “Brain,” of a Sprinkler System. They can wear out or stop working. Power surges in the home can cause damage to a controller.
Programming can be difficult for homeowners. We can help with programming or replace a Sprinkler Module if it is defective.
Start Time Programming
“Start Time” programing many times is confusing for homeowners. The definition of a Start Time is a time that is chosen for the sprinkler system to start watering. It causes zone 1 to start running. When zone 1 is finished it automatically stops and zone 2 begins. When Zone 2 is complete it stops and zone 3 begins. Simple enough Right! This continues until the last zone programed available runs.
The confusion begins when people think that a time needs to be set to start zone 2 and 3 and so on. This is not the case. They follow zone 1 which has the only Start Time programmed into the controller.
Be Careful with Multiple Start Times, just use One at first.
Sprinkler Controllers have a feature providing multiple start times, up to 4 Start Times are usually available. These additional start times are only used when a person wants to run the entire system more than once in a 24-hour period.
For Example, the first Start Time is set at 9Am. Zone 1 begins to run at 9am. When Zone 1 is done, say 10 minutes later, Zone 2 begins and runs for 10 minutes, then zone 3 follows and so on. By 10 am let’s say all the zones have run. Let’s say 8 hours later you have a second start time at 6 Pm. Zone 1 comes on and runs and by 7pm all the zones have run again. So, the controller has 2 start times which have caused the Sprinkler System to run start to finish twice in a 24-hour period.
Here is the big problem! Some Homeowners believe the second start time is to start zone 2 running. They also think that the 3rd start time is to start zone 3 and the 4-start time is to run zone 4. No!!
So, this is how they program the controller. At 9am they have a start time and zone 1 starts. The homeowner programs a second start time at 9:10 am to mistakenly start zone 2. Nope! It starts zone 1 all over again. At 9:2o they have a 3rd start time for zone 3. Nope! It starts zone 1 for a third time. Now the controller is stuck in a loop and zone 1 runs constantly and won’t shut off.
If Sprinkler Controller Programming is confusing? Make sure you only have One Start Time!
“Run Time,” is completed Next. It determines how long each zone runs. Zone One 10 Minutes, Zone Two, 15 Minutes, Zone Three 8 Minutes. You can set how long you want each zone to run.
French Drain Repair and Installation is a Central Focus for Oklahoma Drainage. We installed our first French Drain and completed our first Sprinkler Repair in Norman in 1993.
Oklahoma Drainage and Sprinkler Repair can provide the necessary expertise to handle difficult sprinkler repairs.
Oklahoma Drainage and Sprinkler Repair provides Expert Service for Sprinkler Heads, Valves, Controllers and all other Sprinkler System difficulties. We service Norman, Edmond, Oklahoma City, Moore, Yukon, Mustang, and Midwest City.
