Mustang French Drain. Oklahoma Drainage and Sprinkler Repair has installed French Drains in Mustang since 1993.
Most recently a little west of Cemetery RD. We installed a Double Exit French Drain That went all the way around the house. It took us 3 days to install.
Oklahoma Drainage – French Drain Installation, Drainage System Design,
Recently Oklahoma Drainage installed a large 6-inch French Drain in Edmond. The customer had water running under his back porch step and into his basement. We did a Free Drainage Diagnostic and Estimate.
The French Drain design that we proposed would intercept the surface water and subsurface water that was flowing under the steps. The French Drain design called for a 6 inch French Drain to be installed above and several feet away from the steps. It would run around the house parallel to the foundation and about 5 feet to the East.
The French Drain would run past the steps to a point where water must cross the French Drain or run up hill to the steps which in this case was not possible. Once past the steps, the French Drain would transition to Solid 6-inch Drainpipe and continue on around the house to the Pop-Up Emitter downhill in the side yard. Along the way we attached several Gutter Down Spouts into the French Drain.
WHERE WE HAVE WORKED!
In 1993 we had no website. I stuck little signs on the side of the road as advertisement. I got my first Drain Installation work in March of 1993 in Norman. It was in Brookhaven North of Robinson Street on the West side of I 35.
Over the years Oklahoma Drainage and Sprinkler Repair has installed all types of Drainage Systems in almost Every town in Central and Western Oklahoma.
The majority of our customers live in Oklahoma City, Norman, Edmond, Yukon, Mustang, Moore, Midwest City, Del City, Blanchard, New Castle, Yukon and Choctaw.
Oklahoma Drainage and Sprinkler Repair hasn’t been limited to those areas, however. We have also installed French Drains, Surface Drains, Channel Drains, and Sump Pumps in many other cities.
Working Drainage Systems Installed by Oklahoma Drainage also reside in: Lawton, Duncan, Ardmore, Chickasha, Shawnee, Enid, Weatherford, Elk City, El reno and many other places.
If you live in any of these Cities or towns, we have installed a French Drain, Surface Drain, Channel Drain, or Sump Pump within 5 miles of your home.
Here is a description of other recent work.
A little bit North of Downtown Oklahoma City, Oklahoma Drainage installed a 6-inch French Drain between two businesses which were less than three feet apart. The French Drain went between a Law Firm and a Tire shop. Water was leaking through the walls of both businesses. Gutters between the two establishments were dumping a huge amount of water. We installed a 6-inch French Drain between the gutters.
It took a long time to get the dirt out of the trench for the French Drain. It was a very tight fit. We had to use a little red wagon to haul out the dirt for the French Drain and haul back in the crushed limestone for the French Drain. It looked a little silly, but it was the only thing we could find that was narrow enough to fit between the buildings. A French Drain that normally would take 1 day to install took three.
Curb Outlet for French Drain in Edmond
Oklahoma Drainage — Installing – French Drains – Surface Drains – Channel Drains – Sump Pumps
Servicing all of Central and Western Oklahoma since 1993.
Oklahoma Drainage and Sprinkler Repair has been diagnosing and solving Drainage Problems since 1993. Water has the ability to get into places around your home where you really don’t want it to be.
Some drainage problems are easy to solve. Typically, water enters the problem drainage area one way from one source. The really tricky drainage problems occur when water enters the problem drainage area from multiple directions and from multiple sources. Sometimes a secondary water source can’t be seen or identified until the primary water problem source is eliminated.
An example of this occurs when water is running into a problem area in an obvious way over the ground where you can see it.
Simple enough.
A drainage system is installed with a surface drain as the “intake” with drainage pipe running to an exit point. Initially the water drains away, and everything looks great.
The next day water is back and is all around the surface drain, but below the edge and it hasn’t rained at all, so no additional water ran over the surface of the ground to flood the area.
The primary water source was solved, (The surface water run off) but the secondary water source was not. Which was sub-surface water, (ground water) running into the area. A surface drain can’t drain “ground water.” A French Drain should have initially been installed instead of a Surface Drain. A French Drain can drain both Surface Water and Ground Water.
Recently we repaired a broken sprinkler pipe under a sidewalk in Newcastle. The Sprinkler Pipe was 3/4-inch PVC 40 schedule. We cut out the bad section with a Saw Zaw and used Primer and Hot Glue to replace the Pipe.
Oklahoma Drainage and Sprinkler Repair
provide Expert Service for Sprinkler Heads, Valves, Controllers and all other Sprinkler System difficulties. We service Norman, Edmond, Oklahoma City, Moore, Yukon, Mustang, and Midwest City.
Sprinkler Controller Repair is a service provided by Oklahoma Drainage. A Sprinkler Controller is the “Brain,” of a Sprinkler System. They can wear out or stop working. Power surges in the home can cause damage to a controller.
Programming can be difficult for homeowners. We can help with programming or replace a Sprinkler Module if it is defective.
Start Time Programming
“Start Time” programing many times is confusing for homeowners. The definition of a Start Time is a time that is chosen for the sprinkler system to start watering. It causes zone 1 to start running. When zone 1 is finished it automatically stops and zone 2 begins. When Zone 2 is complete it stops and zone 3 begins. Simple enough Right! This continues until the last zone programed available runs.
The confusion begins when people think that a time needs to be set to start zone 2 and 3 and so on. This is not the case. They follow zone 1 which has the only Start Time programmed into the controller.
Be Careful with Multiple Start Times, just use One at first.
Sprinkler Controllers have a feature providing multiple start times, up to 4 Start Times are usually available. These additional start times are only used when a person wants to run the entire system more than once in a 24-hour period.
For Example, the first Start Time is set at 9Am. Zone 1 begins to run at 9am. When Zone 1 is done, say 10 minutes later, Zone 2 begins and runs for 10 minutes, then zone 3 follows and so on. By 10 am let’s say all the zones have run. Let’s say 8 hours later you have a second start time at 6 Pm. Zone 1 comes on and runs and by 7pm all the zones have run again. So, the controller has 2 start times which have caused the Sprinkler System to run start to finish twice in a 24-hour period.
Here is the big problem! Some Homeowners believe the second start time is to start zone 2 running. They also think that the 3rd start time is to start zone 3 and the 4-start time is to run zone 4. No!!
So, this is how they program the controller. At 9am they have a start time and zone 1 starts. The homeowner programs a second start time at 9:10 am to mistakenly start zone 2. Nope! It starts zone 1 all over again. At 9:2o they have a 3rd start time for zone 3. Nope! It starts zone 1 for a third time. Now the controller is stuck in a loop and zone 1 runs constantly and won’t shut off.
If Sprinkler Controller Programming is confusing? Make sure you only have One Start Time!
“Run Time,” is completed Next. It determines how long each zone runs. Zone One 10 Minutes, Zone Two, 15 Minutes, Zone Three 8 Minutes. You can set how long you want each zone to run.
French Drain Repair and Installation is a Central Focus for Oklahoma Drainage. We installed our first French Drain and completed our first Sprinkler Repair in Norman in 1993.
Oklahoma Drainage Installs Drainage Systems, and provides Expert Sprinkler System Repair.
Our Drainage Systems utilize French Drains, Surface Drains, Channel Drains, and Sump Pumps.
We Service all of Central Oklahoma including: Norman, Moore, Edmond, Yukon, Mustang, Oklahoma City, Midwest City, Del City, Blanchard, Newcastle, Purcell and Chickasha.
Back-Flow-Valve Service, Sprinkler Repair
Oklahoma Drainage and Sprinkler Repair Provides Service for Back-Flow-Valves and all types of Lawn Sprinkler Repair and Service. We have provided Expert Service for all of Central and Western Oklahoma Since 1993.
Back-Flow-Valves
There are two types of Back-Flow-Valves.
Above Ground
Above Ground Back-Flow-Valve.
Below Ground Back-Flow-Valve.
Below Ground Back-Flow-Valve
What is a Back-Flow-Valve?
A Back-Flow-Valve is a part of a Lawn Sprinkler System. Water passes through it from the water source which can be a Water Meter or a Well Pump. It forces water to travel in only one direction from the source to the sprinkler system. It can’t travel backward back to the water source which again is a water meter or well pump.
A Back-Flow-Valve provides protection to the water source from back pressure and chemical contamination from lawn fertilizer.
Most Cities require a Back-Flow-Valve as “Code” for Sprinkler Installation.
Emergency Shut off
Back-Flow-Valves usually have an Emergency Shutoff valve on them that can shut off the water to the lawn sprinkler system but keep the water turned on to the home. Most Back-Flow-Valves have two Emergency Shut off Handles. Either one will work. Many times, they are hard to turn, however.
If there is a leak or water is shooting up in the air just turn the valve handle and give us a call.
Blue Emergency Shutoff handles for a Back-Flow-Valve.
Norman Sprinkler Checkup is a Central Focus for Oklahoma Drainage. We Performed or first Sprinkler Repair in Norman in 1993. It was in Brookhaven on the West side of Norman.
Recently we had a customer in Oklahoma City who wanted to move his Sprinkler Valves. They were in a bad place in his flower bed. He wanted to plant a tree where the valves were located.
We moved 4 Sprinkler Valves about feet out into the yard. All the Sprinkler Pipes had to be redesigned and installed matching the new location and maintaining full functionality.
Newcastle Sprinkler Repair
What Is a Sprinkler Valve?
Think of a Sprinkler Valve as an “Off or On” Switch. The Sprinkler Controller turns the valves on or off.
It Sends a signal through a wire which is underground to the sprinkler valve somewhere in your yard.
Once turned on, the valve lets water pass through a sprinkler pipe to a specific group of sprinkler heads called a Sprinkler Zone. The controller allows water to reach the sprinkler heads for a certain amount of time running through the sprinkler valve. Once the time is up, it shuts off the sprinkler valve and moves on to the next valve in sequence.
Think of it as walking into every room in your house one at a time. As you enter you turn on the light. As you leave you turn off the light and move to the next room. You are the controller. The light switch represents the sprinkler valve.
What causes a Sprinkler Valve to stop working?
Like anything else, a sprinkler valve can wear out. Sprinkler valves fail in closed position. It won’t run continuously if it breaks.
Sprinkler Valves get stuck while running sometimes. The water supply must be then turned off to stop the Sprinkler from running.
Sprinkler Valves can freeze and break in the winter if the sprinkler system has not been properly drained for winter’s cold.
(winterized)
Tree roots can twist or break sprinkler pipes running into sprinkler valves. Magnolia Trees are really bad about this. Oak trees can cause damage too.
Driving something heavy across your yard can crush sprinkler valves. Usually riding lawnmowers don’t cause damage but any truck or car will if you drive over a valve.
Sometimes things go wrong with sprinkler systems.
IF YOU NEED HELP
OKLAHOMA DRAINAGE AND SPRINKLER REPAIR. 405 203 9419
One Common problem is that they continue to run and won’t shut off. In most cases this is a problem with a sprinkler valve that has “Stuck” in the on position.
This can be temporarily solved by shutting of the Emergency Shutoff Valve. The problem is that some sprinkler systems don’t have one to turn off or if they do the homeowner doesn’t know where it is.
It may be on the back-flow valve which may be located on the side of the house under a big plastic fake rock.
Many sprinkler systems in Oklahoma have them. (50 % ?) Under the plastic rock is a back-flow valve with two shut off handles. Usually, they have blue or green or tan handles. Turn one of the handles and it should shut off the water to your sprinkler system.
Other times the Emergency Shutoff Valve is in a box in the ground out by the curb near your water meter. The valve box will have a green lid. Sometimes they are difficult to open. Many times, I had to pry them open with a flat head screwdriver.
