Edmond Sprinkler Repair is a big focus for Oklahoma Drainage and Sprinkler Repair. We have been fixing broken sprinkler heads and Replacing Sprinkler Valves in Edmond since 1993. Not only that, we service Sprinkler Controllers, find and fix leaks and do General Sprinkler Checkups.
405 203 9419
Recently in Edmond
Many times, Sprinkler heads get, “Out of Wack.” Lawn mowers and weed eaters are notorious for this. Sprinkler heads start spraying water in the wrong place. It is frustrating to water concrete while plants and grass go without moisture. Sprinkler Heads that are out of adjustment can spray out into the street or blast your front door.
Recently we had a customer who had sprinkler heads that were spraying out into the street more than they were hitting her yard.
The problem sprinkler head was out of adjustment. The Rotor Sprinkler Head was turning too far to the right as it turned. Water was spraying across the road and into the neighbor’s yard.
The Sprinkler Head Adjustment only took a few minutes. Our customer then requested that we check the entire sprinkler system. We started at Zone one and carefully put each zone through its Paces.
Edmond Sprinkler Repair
Sprinkler Controller Programming is sometimes difficult.
We can help with programming or replace a Sprinkler Module if it is defective.
“Start Time” programing many times is confusing for homeowners. The definition of a Start Time is a time that is chosen for the sprinkler system to start watering. It causes zone 1 to start running. When zone 1 is finished it automatically stops and zone 2 begins. When Zone 2 is complete it stops and zone 3 begins. Simple enough Right! This continues until the last zone programed available runs.
The confusion begins when people think that a time needs to be set to start zone 2 and 3 and so on. This is not the case. They follow zone 1 which has the only Start Time programmed into the controller.
Sprinkler Controllers have a feature providing multiple start times, up to 4 Start Times are usually available. These additional start times are only used when a person wants to run the entire system more than once in a 24-hour period.
Sprinkler Controller
For Example, the first Start Time is set at 9Am. Zone 1 begins to run at 9am. When Zone 1 is done, say 10 minutes later, Zone 2 begins and runs for 10 minutes, then zone 3 follows and so on. By 10 am let’s say all the zones have run. Let’s say 8 hours later you have a second start time at 6 Pm. Zone 1 comes on and runs and by 7pm all the zones have run again. So, the controller has 2 start times which have caused the Sprinkler System to run start to finish twice in a 24-hour period.
Here is the big problem! Some Homeowners believe the second start time is to start zone 2 running. They also think that the 3rd start time is to start zone 3 and the 4-start time is to run zone 4. No!!
The Mistake
So, this is how they program the controller. At 9am they have a start time and zone 1 starts. The homeowner programs a second start time at 9:10 am to mistakenly start zone 2. Nope! It starts zone 1 all over again. At 9:2o they have a 3rd start time for zone 3. Nope! It starts zone 1 for a third time. Now the controller is stuck in a loop and zone 1 runs constantly and won’t shut off.
“Run Time,” is completed Next. It determines how long each zone runs. Zone One 10 Minutes, Zone Two, 15 Minutes, Zone Three 8 Minutes. You can set how long you want each zone to run.
We rebuilt a Sprinkler System that hadn’t worked in years. This took place in West Yukon.
Sprinkler Head Replacement
We started with the Valves
The Sprinkler Valves were located in the back yard near the pool. Six valves were located in one place. They were very tightly connected in one Manifold. None of the Sprinkler Valves had worked in a long time. They were Toro Valves that were over 20 years old. They all had to be replaced.
Surprisingly there was no shut-off valve for the Sprinkler Water. The water had to be shut off at the Meter so we could install a Manual Shut off valve. Once installed, the water was turned back on that ran to the house. The water that ran to the Sprinkler System was shut off with our New Shut Off Valve.
Now, the 6 valves had to replaced. The valves that were used were made by Rain Bird. Before we began, I had to talk to the Customer. The previous valve design was a bad idea to repeat.
The original Sprinkler Valves were crammed into one large valve box in one very tight manifold. This is bad because the valves were too close to the fittings. Simply put, if one valve had to be replaced or worked on in the future, all 6 valves had to be taken out and replaced. If one valve was bad and 5 worked fine, they all still had to be replaced.
That’s Stupid!
I recommended that an additional Valve Box be installed putting 3 valves in each Valve Box. This would allow plenty of space between the valve fittings. If one Sprinkler Valve had to be adjusted or replaced in the future, the other 5 valves need not be disturbed. Simple Enough!
Once the valves were replaced and working, it was time to turn on each Sprinkler Zone, one at a time. Water was shooting up from the ground in several places in zone 1. Two broken Sprinkler Pipes and 5 bad Sprinkler Heads in zone 1 had to be fixed and replaced. We went through each of the 6 zones in similar fashion fixing lots of leaks and replacing bad sprinkler heads.
One Common problem
is that they continue to run and won’t shut off. In most cases this is a problem with a sprinkler valve that has “Stuck” in the on position.
This can be temporarily solved by shutting of the Emergency Shutoff Valve. The problem is that some sprinkler systems don’t have one to turn off or if they do the homeowner doesn’t know where it is.
It may be on the back-flow valve which may be located on the side of the house under a big plastic fake rock.
Many sprinkler systems in Oklahoma have them. (50 % ?) Under the plastic rock is a back-flow valve with two shut off handles. Usually, they have blue or green or tan handles. Turn one of the handles and it should shut off the water to your sprinkler system.
Emergency Shutoff Valve
Other times the Emergency Shutoff Valve is in a box in the ground out by the curb near your water meter. The valve box will have a green lid. Sometimes they are difficult to open. Many times, I had to pry them open with a flat head screwdriver.
Back-Flow-Valve Service, Sprinkler Repair
Oklahoma Drainage and Sprinkler Repair Provides Service for Back-Flow-Valves and all types of Lawn Sprinkler Repair and Service. We have provided Expert Service for all of Central and Western Oklahoma Since 1993.
There are two types of Back-Flow-Valves.
Note! Some Lawn Sprinkler Systems will have no Back-flow Valve at all. Most Systems do, but the System can function without it.
Above Ground
Below Ground Back-Flow-Valve.
Below Ground Back-Flow-Valve
What is a Back-Flow-Valve?
A Back-Flow-Valve is a part of a Lawn Sprinkler System. Water passes through it from the water source which can be a Water Meter or a Well Pump. It forces water to travel in only one direction from the source to the sprinkler system. It can’t travel backward back to the water source which again is a water meter or well pump.
A Back-Flow-Valve provides protection to the water source from back pressure and chemical contamination from lawn fertilizer.
Most Cities require a Back-Flow-Valve as “Code” for Sprinkler Installation.
Emergency Shut off
Back-Flow-Valves usually have an Emergency Shutoff valve on them that can shut off the water to the lawn sprinkler system but keep the water turned on to the home. Most Back-Flow-Valves have two Emergency Shut off Handles. Either one will work. Many times, they are hard to turn, however.
If there is a leak or water is shooting up in the air just turn the valve handle and give us a call.
Inside the valve box is a plastic handle that can turn off the water to the sprinkler system. It can be blue or red or grey in color.
Many times, the valve box will be full of dirt, and you can’t turn or even see the handle until some of the dirt has been dug out by hand.
Water might be shooting up in the air somewhere on your property. This can be caused by a broken sprinkler pipe or sprinkler valve.
SHUT OFF THE SPRINKLER WATER IF YOU CAN AND GIVE US A CALL.
405 203 9419
Servicing Oklahoma City, Norman, Edmond and all of Central and Western Oklahoma
The Sprinkler Repair Cost About Half of the Cost of Completely New System.
Sprinkler Repair Service Provided by Oklahoma Drainage and Sprinkler Repair
Since 1993 we have Replaced Sprinkler Valves that were sticking or were wore out.
Thousands of Sprinkler Heads have been adjusted.
Countless Sprinkler Controllers have been Reprogramed or Replaced.
We also have fixed a broken Sprinkler Pipe or Two. Seems like a million. Ok, not that many.
I wonder how many? A lot!!!!
Oklahoma Drainage and Sprinkler Repair provide Service for all of Central Oklahoma Including: Oklahoma City, Norman, Edmond, Moore, Yukon and Mustang.
Oh! we also solve water problems and provide Drainage.
If You live in Oklahoma City and water damaging your foundation, We can install a French Drain for you.
Or,If you live in Norman and have water standing on your driveway, consider a Channel Drain Installation.
If you live in Edmond and have water flooding your basement, a Sump Pump can help.
Or, you live in Moore and have water washing out your flower bed mulch, We can install a Surface Drain for you.
If you live in Yukon and need grass to grow, we can install Sod too!
Do you have water standing in your yard after a heavy rain? Do your gutters turn your sidewalk into a moat after a storm. Worst of all, do you have water seeping into your home or business from Storm-Water runoff?
Oklahoma Drainage can help with these and many other “standing water” and ” Drainage Problems. We can diagnose your drainage problem and design a drainage system to fit your specific needs. In Business since 1993.
We utilize: French Drains, Surface Drains, Channel Drains, Basin Drains, Trench Drains, Basement Drains, and Sump Pumps.
We service all of Central and Western Oklahoma
